RF Mogul Eagle Specifications download pdf (Page 5)

STOP !!!

STOP !!!STOP !!!

STOP !!!

YOU MUST CHECK AND CORRECT THE FOCAL POINT OF YOUR

DISH BEFORE DOING BEGINNING YOUR INSTALL. FAILURE TO DO

SO WILL CREATE PROBLEMS IN ACQUISITION!!!

(See page 13 for details)

Requirements for Installation

•

Color Blind? Ask a friend or neighbor for assistance. Meet a new friend.

•

Patience and attention to details will make this go smoothly. Do not rush

through this document. Analyze each step and consider the implications of

skipping or ignoring any of the steps or recommendations. The correct LNB

must be installed for the software used. Failure to do so will result in the

system not performing an automatic acquisition.

o Shaw 60cm dish must use a 60E LNB

o Shaw 70cm or 75cm HD dish must use a 75E LNB

•

GPS must be mounted where it can best receive the signal from the GPS

satellites.

•

All entry holes in the roof must be sealed properly to prevent water damage

from leaks.

•

Do not splice the GPS cable. If longer lengths are required please request

them from the factory.

•

If the roof is fiberglass or rubber coated (not metal) then the GPS may be

installed inside the RV. It must be unobstructed wherever it is installed.

•

Do not stack electronic components because of potential heat problems.

Most receivers produce a lot of heat even when turned OFF. HEAT is a

primary cause of system failure to perform properly. Do not stack the

controller on top of the receiver.

1 2 3 4 5 6 7 8 9 10 ... 16 17

No comments

RF Mogul Eagle Specifications Page 5